ENDA ETC 9420 PDF

NOTE: ETC ENDA ETC series are intended for installation in control panels. Make sure that the device is used only for intended purpose. The shielding. Thank you for choosing ENDA EPC profile controller. * Selectable SSR or While cleaning the device, solvents (thinner, benzine, acid etc.) or corrosive. Double set point. Selectable sensor type (Pt, J, K, L, T, S, R). PID control function with accurate self-tuning. Digital inputs can be assigned to 3 different.

Author: Nijin Nagrel
Country: Ethiopia
Language: English (Spanish)
Genre: Video
Published (Last): 16 September 2012
Pages: 58
PDF File Size: 12.23 Mb
ePub File Size: 11.88 Mb
ISBN: 686-5-23441-540-9
Downloads: 53158
Price: Free* [*Free Regsitration Required]
Uploader: Shagore

The normal value is 0. If no key is pressed within 20 seconds during programming mode, the data is stored automatically and the run mode is entered. The maximum of C.

Process value during normal operation Mnemonic parameter code during programming SV Display: Make sure that the device is used only for intended purpose. If any key is pressed while P. After 1 second following the release of the key, initial condition is returned. Otherwise, Self-Tune should be activated. The installation and electrical endw must be carried on by a qualified staff and must be according to the relevant locally applicable regulations. The maximum value is the value of A1.

Difference addresses should be selected for every device.

Enda ETC Series PID Temperature Controllers Panel Mount | Rapid Online

If process value is Appropriate to begin self tune, rEdY. Before self tune procedure, temperature setpoint value should be adjusted. Etx cleaning the device, solvents thinner, benzine, acid etc. If independent or deviation alarm is selected, this parameter can be Lo. So the set point can be achieved by minimum fluctuations and in the shortest time.

Enda ETC Series PID Temperature Controllers Panel Mount

Use suitable compensation cables. While holding 25 REdY.

The shielding must be grounded on the instrument side. Adjusable between 1 and It should be Relative humidity According to EN Front panel: Therefore, when using a grounding thermocouple, do not connect the logic output terminals to the ground.

Technical Specification

SEt is the value of C. When 2 wired Pt is used, terminals that are shown at the right of there must be short circuited for each product. When self tune procedure begins with no failure, Pid. Four kinds of functions can be selected.

Using this parameter the energy requirements enca the system is adjusted at the set point. S different from out1. It’s a community-based project which helps to repair anything. Alternatively, the same function occurs first pressing Entering from the programming mode to the run mode: UnIt Offset value is added to the measurement value.

IfInp parameter is selected TC or Pt, this parameter is seen. If waited enough,the value increases at each step. When PID parameters are Filter for display value. RS Modbus communication None During an installation, all of the cables that are connected to the device must be free of energy. Then, the value is adjusted by using PV A1. If this parameter is enfa to a value closer to the energy requirements of the system at the set point, process temperature is prevented to rise or drop to dangerous levels.

If this parameter wnda 1, digital filter runs most quick. If the selected input type is changed, the value of C. The maximum value is the value of C. Adjustable between ends and minutes. Then, the value is adjusted by using If C. Adjustable between 1 and seconds.

If this parameter is set to 0, the output power becomes 0 at the set point. The device must be protected against inadmissible humidity, vibrations, severe soiling and make sure that the operation temperature is not exceeded.

Pay attention to the polarities of the thermocouple cables as shown in end figure right are connected to the. If self tune is achieved A.