CCNA 3 FINAL EXAM ANSWERS PDF

CCNA 3 Final Exam Answers (v+v) – Scaling Networks 1. A network designer is considering whether to implement a swit. View Test Prep – -CCNA 3 Final Exam Answers vv60 Scaling Networks (1).pdf from S at Deakin. CCNA 3 Final Exam Answers CCNA 3 Final Exam V Answers only computer 4 CCNA 2 Final Exam V Answers computer 3 and RTR-A CCNA 1 Chapter 10 V Answers computer 4.

Author: Zugrel Voodoorg
Country: Kosovo
Language: English (Spanish)
Genre: Life
Published (Last): 7 July 2015
Pages: 396
PDF File Size: 9.10 Mb
ePub File Size: 5.41 Mb
ISBN: 796-3-64503-378-1
Downloads: 77897
Price: Free* [*Free Regsitration Required]
Uploader: Voodoosida

The link between the switches is up but not trunked. December 14, at 9: Documents Flashcards Grammar checker.

Which switch will become the root for VLAN 20? One of the router subinterfaces is possibly down. The Layer 2 switching design that is shown has been implemented in a campus environment that is using Spanning Tree Protocol. It prevents loops aswers a switched network with redundant paths.

What is one disadvantage that Other PCs on the switch can consistently ping fianl default gateway. Which type of traffic can still be received on a switch interface that is in STP blocking mode?

All inter-switch links that are shown are trunks. Add a trunk link that directly connects D1 and D2.

What will commonly cause this problem? The link between Switch1 and Switch2 is up but not trunked.

CCNA 3 Final Exam V Answers

This allows the switch to host web pages for the network. Statically configured MAC addresses will automatically be removed from the address table minutes after the last activity on a switch port. A backup configuration from a TFTP server cannot be copied directly into the startup-config. March 24, at 9: July 13, at 2: An administrator is troubleshooting a PC on the network which is suffering from slow and intermittent connectivity. Easily MAC addresses are spoofed.

It is plain wrong. The switch port fails to autonegotiate the duplex setting and defaults to half duplex, which causes a duplex mismatch. SW1 leaves the traffic untagged and forwards it over the trunk.

CCNA 3 v6.0 Exam Answers 2018 score 100%

answere The switch traffic is exceeding available frame buffers. A company has acquired a new office in a campus environment. This is required if a web server or web farm is attached to the switch. October 13, at A successful trunk will be established if the remote switch is non-Cisco but the port is configured for trunking.

Router RA receives a packet with a source address of Attach the web server to a router and configure inter-VLAN routing.

The erase flash command will clear all statically configured table entries. The clear switching-tables command will remove statically configured entries. Which device or devices will receive this message? The PC is set to full duplex. It is configured in VTP server mode. What could be the reason for this?

Physically connect to the access point and then reboot the computer to launch the configuration software.