ASTM D5894 PDF
ASTM D is a cyclic salt fog combined with a UV exposure test sequence for painted metal samples offered by Micom Laboratories. 13 Aug This standard is issued under the fixed designation D ; the 1 This practice is under the jurisdiction of ASTM Committee D01 on Paint and. To determine weathering and corrosion resistance according to test methods ASTM D and ISO , paint manufacturers and buyers can use the.
|Published (Last):||11 February 2017|
|PDF File Size:||7.46 Mb|
|ePub File Size:||3.93 Mb|
|Price:||Free* [*Free Regsitration Required]|
No other units of measurement are included in this standard. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.
Results obtained from astmm conducted according to this practice can be considered as representative of actual outdoor exposures only when the degree of rank correlation has been established for the specific materials being tested. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
It does not specify specimen preparation nor evaluation of results. Historical Version s – view previous versions of standard. The relative durability of materials in actual outdoor service can be very different in different locations because of differences in UV radiation, time of wetness, temperature, pollutants, and other factors.
Because of possible variability between the same type of exposure devices, it is not recommended to aztm the amount of degradation in materials exposed for the same duration at separate times, or in separate devices running the same test condition. This practice is intended to provide a more realistic simulation of the interaction of these factors than is found in traditional tests with continuous exposure to a static set of corrosive conditions.
Link to Active This link e5894 always route to the current Active version of the standard. Different materials and different formulations of the same material can have significantly different acceleration factors. These factors frequently have a synergistic effect on one another.
Therefore, even if results from a specific artificial test condition are found to be useful astmm comparing the relative durability of materials exposed in a particular exterior environment, it cannot be assumed that they will be useful for determining relative durability for a different environment.
The acceleration factor also varies depending on the variability in rate of degradation in the laboratory test and in actual outdoor exposure.